The pictures used in this section may not look exactly like your robotic cleaner but troubleshooting procedures should work with your cleaner!

10. Winterizing instructions:

• Remove robot from the pool and place near a water hose

• Remove the bottom lid and filter bag

• Empty filter bag, turn it inside out and clean filter bag thoroughly with a high pressure hose

• Spray the outside of the robot and remove any debris

• Turn it over and thoroughly spray the inside of the robot, brushes, lock tabs, shafts and bearings

• Install the filter bag and reinstall reassemble on bottom lid

• Position the Grommet holes so they are at each end of the wire forms. The blue label should be located in the middle of the long side of the bottom lid.

• Install bottom lid back into the cleaner

• Push in the bottom lid until all the tabs are securing the bottom lid to the Robot’s body

• Ensure the Robot is completely dry then place in a box and tape close. Keep box in a dry, warm, clean storage area for the winter season.