The pictures used in this section may not look exactly like your robotic cleaner but troubleshooting procedures should work with your cleaner!

5. Pool floor partially cleaned:

• Shut Power supply off and remove Robotic Cleaner from the pool

 

• Turn cleaner on its top carefully. Put cardboard, towel or blanket under cleaner so not to scratch plastic surfaces.

• Remove the bottom lid assembly
  (This is the tray that holds the filter bag)

• Remove filter bag from the wire forms

• Empty filter bag, turn it inside out and clean thoroughly with a high pressure hose

• Install the filter bag on the wire forms and reinstall reassemble on the bottom lid

• The blue label should be located in the middle of the long side of the bottom lid and the grommet holes are placed at each end

• Install bottom lid back into the cleaner

• Check to ensure the bottom cover is secured properly

• Inspect and Clean the pump propeller.
  Remove the 2 Phillips head screws from the outlet top.

• Carefully remove out let top from the robot and set aside

• Remove all debris from the propeller using tweezers or needle nose pliers

• After thorough inspection, reinstall outlet top (Reverse of removal procedure)

 

• Place cleaner into the pool and turn on

 

• If the problem still exist, fill out a Service Request Form or call 1-800-457-7642 for additional help